Abstract

A method for obtaining a high-contrast visible-light signal from infrared absorption in low-absorbance samples is described. This method is based on a beam-fanning optical limiter in photorefractive BaTiO₃. The resulting signal is not linear but does exhibit an enhanced signal-to-background ratio that is 4 to 6 orders of magnitude better than that of conventional infrared absorption spectrophotometry in the shot-noise limit. A simple model for the beam-fanning, optical-limiter-based, pulsed-laser-excited photothermal spectroscopy detector is found to describe the experimental data adequately. This technique using photothermal spectroscopy detection may have advantages for rapid signal analysis and for two-dimensional visible imaging of infrared absorption.

© 1989 Optical Society of America

Energy transfer between injection-locked single-mode diode lasers by two-beam coupling in BaTiO₃

William R. Christian, Paul H. Beckwith, and Ian McMichael
Opt. Lett. 14(1) 81-83 (1989)

Accounting for absorption saturation effects in pulsed infrared laser-excited photothermal spectroscopy

Stephen E. Bialkowski
Appl. Opt. 32(18) 3177-3189 (1993)

Vibrational mid-infrared photothermal spectroscopy using a fiber laser probe: asymptotic limit in signal-to-baseline contrast

Atcha Totachawattana, Hui Liu, Alket Mertiri, Mi K. Hong, Shyamsunder Erramilli, and Michelle Y. Sander
Opt. Lett. 41(1) 179-182 (2016)

Ultrashort-pulse multichannel infrared spectroscopy using broadband frequency conversion in LiIO₃

E. J. Heilweil
Opt. Lett. 14(11) 551-553 (1989)

Optical quadratic processor using four-wave mixing in BaTiO₃

Gregory N. Henderson, John F. Walkup, and Erik J. Bochove
Opt. Lett. 14(15) 770-772 (1989)