Abstract
In compression molding of polymer optical components with micro/nanoscale surface features, rapid heating of the mold surface is critical for the implementation of this technology for large-scale applications. In this Letter, a novel method of a localized rapid heating process is reported. This process is based on induction heating of a thin conductive coating deposited on a silicon mold. Since the graphene coating is very thin (), a high heating rate of can be achieved by employing a 1200 W 30 kHz electrical power unit. Under this condition, the graphene-coated surface and the polymer substrate can be heated above the polymer’s glass transition temperature within 30 s and subsequently cooled down to room temperature within several tens of seconds after molding, resulting in an overall thermal cycle of about 3 min or shorter. The feasibility of this process was validated by fabrication of optical gratings, micropillar matrices, and microlens arrays on polymethylmethacrylate (PMMA) substrates with very high precision. The uniformity and surface geometries of the replicated optical elements are evaluated using an optical profilometer, a diffraction test setup, and a Shack–Hartmann wavefront sensor built with a molded PMMA microlens array. Compared with the conventional bulk heating molding process, this novel rapid localized induction heating process could improve replication efficiency with better geometrical fidelity.
© 2017 Optical Society of America
Full Article | PDF ArticleMore Like This
Lin Zhang and Allen Y. Yi
Opt. Express 29(19) 30761-30771 (2021)
Peng He, Lei Li, Jianfeng Yu, Wenyi Huang, Ying-Chieh Yen, L. James Lee, and Allen Y. Yi
Opt. Lett. 38(14) 2625-2628 (2013)
Lihua Li, Ming-Kit Chan, Wing-Bun Lee, Man-Cheung Ng, and Kin-Leung Chan
Opt. Lett. 44(14) 3454-3457 (2019)