Abstract

This paper presents the results of the laser drilling of deep microholes (150 µm in diameter, aspect ratio up to 35) in refractory alloys. A Nd:YAG laser that generates a sequence of millisecond pulse bursts (individual pulse width 150-550 ns, pulse-repetition rate in a burst 3.5-50 kHz) was used in the experiments as the laser radiation source. The parameters of holes obtained with various parameters of the laser beam were determined by means of microstructural analysis. © 2005 Optical Society of America

PDF Article

Cited By

You do not have subscription access to this journal. Cited by links are available to subscribers only. You may subscribe either as an OSA member, or as an authorized user of your institution.

Contact your librarian or system administrator
or
Login to access OSA Member Subscription