Abstract

Brillouin amplification of a CW laser is evaluated by a coherent receiver and offline digital signal processing (DSP) to assess electric field distortions relevant to noise sensitive applications, and in particularly, optical communications. In this approach, the Brillouin amplifier output is heterodyne detected at the receiver so that the proportional electric field restored by DSP can be resampled into a virtual quadrature phase shift keyed (QPSK) signal. From this, an effective Q2-factor distortion and amplitude and phase error are quantified. Characterization by the approach of Brillouin gain in a 4.46 km standard signal mode fiber shows amplitude error as the dominant noise feature while impact from phase error is generally negligible. Large gain ≈≥26 dB with minimal Q2 factor degradation <1 dB is observed achievable but with constraints on 1) input and 2) pump powers, and alignment of 3) frequency, and 4) state of polarization (SOP) for peak gain. Detuning of the SOP for minimum gain is observed to excite low frequency amplitude pulsations that grow in intensity and frequency with increasing pump power. For frequency detuning, signature amplitude and phase distortion patterns are uniquely visualized by the virtual QPSK constellations. Spectral analysis by DSP indicate an output carrier to noise ratio as being capped to ≈40 dB at 30 dB gain for the particular test fiber and noise as highly polarized. The characterized low noise and operating constraints of the Brillouin amplifier demonstrated by the approach aids design for noise sensitive applications.

Analytical estimation of laser phase noise induced BER floor in coherent receiver with digital signal processing

Evgeny Vanin and Gunnar Jacobsen
Opt. Express 18(5) 4246-4259 (2010)

Low noise frequency comb carriers for 64-QAM via a Brillouin comb amplifier

Mark Pelusi, Amol Choudhary, Takashi Inoue, David Marpaung, Benjamin J. Eggleton, Karen Solis-Trapala, Hung Nguyen Tan, and Shu Namiki
Opt. Express 25(15) 17847-17863 (2017)

Characterization of semiconductor-laser phase noise and estimation of bit-error rate performance with low-speed offline digital coherent receivers

Kazuro Kikuchi
Opt. Express 20(5) 5291-5302 (2012)

Digital coherent receiver based transmitter penalty characterization

David J. Geisler and John E. Kaufmann
Opt. Express 24(26) 29734-29748 (2016)

Chip-based Brillouin processing for carrier recovery in self-coherent optical communications

Elias Giacoumidis, Amol Choudhary, Eric Magi, David Marpaung, Khu Vu, Pan Ma, Duk-Yong Choi, Steve Madden, Bill Corcoran, Mark Pelusi, and Benjamin J. Eggleton
Optica 5(10) 1191-1199 (2018)