Abstract

The temperature compensation effect strongly influences the measurement accuracy of FBG sensors. The most widely used compensation methods can be classified into three types depending on the FBG encapsulation method: 1) dual-grating differential measurement for fully pasted FBGs, 2) dual-grating differential measurement for prestretched FBGs with both ends fixed, and 3) the addition of a temperature-reference FBG. In current reports, temperature compensation is performed based on the assumption that the wavelength shifts of the two FBGs are the same (or proportional to each other) and are synchronous with the temperature variation. However, because of uncertainties in workmanship and the thermal flow differences between different encapsulated FBGs, the validity of this assumption is doubtful. In this paper, the compensation characteristics of each method at different heating rates are investigated through a series of experiments and theoretical analyses. A detailed comparative analysis shows that Method 2 can be considered the optimal temperature compensation scheme in terms of both compensation accuracy and stability, whereas Method 1 is slightly inferior to Method 2. In addition, Method 3 is roughly equivalent to Method 1 and slightly inferior to Method 2 when the heating rate is <0.8 °C/min; however, when the heating rate is ≥1 °C/min, Method 3 is considerably inferior to both Method 1 and Method 2. The results indicate that the compensation effect is determined by both the FBG encapsulation method and the temperature change rate, thus revealing the deficiency of the current compensation assumption.

© 2018 IEEE

FBG-based three-dimensional micro-force sensor with axial force sensitivity-enhancing and temperature compensation for micro-forceps

Xiaodong Zhang, Hongcheng Liu, Yachun Wang, Yiwei Xiong, and Hang Niu
Opt. Express 31(24) 40538-40556 (2023)

Dynamic large strain measurement under high-temperature environment using a modified FBG sensor and plasma surface treatment

Jindong Wang, Zhiyuan Wang, Liyang Jin, Juan Li, Jingsheng Huang, and Tao Zhu
Opt. Express 31(11) 17514-17527 (2023)

Material features based compensation technique for the temperature effects in a polymer diaphragm-based FBG pressure sensor

Arnaldo Leal-Junior, Anselmo Frizera, Camilo Díaz, Carlos Marques, Moisés Ribeiro, and Maria José Pontes
Opt. Express 26(16) 20590-20602 (2018)

Method of simultaneous measurement of two direction force and temperature using FBG sensor head

Piotr Kisała and Sławomir Cięszczyk
Appl. Opt. 54(10) 2677-2687 (2015)

Separation method of bending and torsion in shape sensing based on FBG sensors array

Xinhua Yi, Xiangyan Chen, Hongchao Fan, Fei Shi, Xiaomin Cheng, and Jinwu Qian
Opt. Express 28(7) 9367-9383 (2020)