Abstract

Fourier transform infrared (FT-IR) imaging was used to successfully explore several factors influencing the dissolution of poly(ethylene oxide). The effect of the degree of crystallinity on the rate of dissolution of mid-range molecular weight PEO was negligible over the temperature ranges studied. The influence of molecular weight on polymer dissolution was found to be much greater than the changes in morphology. An examination of the polymer and solvent images and absorbance profiles, compared with the results of the bulk polymer/solvent boundary movement, confirmed this relationship. An investigation of the bulk polymer/solvent boundary using a crystalline-sensitive polymer band showed the crystalline to amorphous phase change occurred over a short distance. Moreover, solvent diffusion ahead of the bulk polymer/solvent front was minimal, most likely a result of the required phase change, which in turn regulated the degree of solvent ingress. Modeling of the dissolution was performed using the Peppas (power law) model. Physical parameters of the dissolution process were obtained from fitting the release profiles to the power law (fraction released = <i>k</i> × <i>t</i>, where <i>k</i> is the dissolution rate constant and <i>n</i> is the release exponent). Results indicated the model worked well to describe dissolution at all molecular weights. By varying the number of data points input to the model and then comparing the generated graphs, it becomes clear that not only does the dissolution slow down over the course of the experiment, but an increase in molecular weight enhances this effect. The effect of different types of drug on the rate of polymer dissolution was also studied. The dissolution of neat polymer was compared to the dissolution of polymer containing 10% (by weight) of theophylline, etophylline, or testosterone. The general trend of all the dissolution curves was the same, with the addition of etophylline and testosterone tracing almost the same route in terms of movement of the bulk polymer/solvent front.

Perovskite interface defect passivation with poly(ethylene oxide) for improving power conversion efficiency of the inverted solar cells

Chengyi Duan, Xiaofei Zhang, Zheren Du, Jia Chen, Ramy El-Bashar, S. S. A. Obayya, Mohamed Hameed, and Jun Dai
Opt. Express 31(12) 20364-20376 (2023)

Optical fiber long-period grating humidity sensor with poly(ethylene oxide)/cobalt chloride coating

Maria Konstantaki, Stavros Pissadakis, Stergios Pispas, Nicholas Madamopoulos, and Nikos A. Vainos
Appl. Opt. 45(19) 4567-4571 (2006)

Investigation of the optothermal properties of a new polymeric blend: polymethyl-methacrylate–poly(ethylene-co-vinylacetate)

U. Bernini, G. Carbonara, M. Malinconico, P. Mormile, P. Russo, and M. G. Volpe
Appl. Opt. 31(27) 5794-5798 (1992)

Optical properties of polycarbonate/styrene-co-acrylonitrile blends: effects of molecular weight of the matrix

Ping Yi, Ying Xiong, and Shaoyun Guo
Appl. Opt. 54(34) 10000-10008 (2015)

Second-order nonlinear optical effects in novel side-chain liquid crystalline polymers and monomers under bias of an applied dc electric field

W. M. K. P. Wijekoon, Y. Zhang, S. P. Karna, P. N. Prasad, A. C. Griffin, and A. M. Bhatti
J. Opt. Soc. Am. B 9(10) 1832-1842 (1992)