Expand this Topic clickable element to expand a topic
Skip to content
Optica Publishing Group
  • Applied Spectroscopy
  • Vol. 45,
  • Issue 3,
  • pp. 501-504
  • (1991)

Some Comments on the Temperature Measurement in a CO2 Laser Beam by Laser-Induced Fluorescence of O2: Improvement of the Method

Not Accessible

Your library or personal account may give you access

Abstract

In a recent paper, we used induced fluorescence of O<sub>2</sub> excited by a broad-band ArF laser to measure the temperature in a CO<sub>2</sub> laser beam. In this preliminary work, only the peak around 235 nm of the hot O<sub>2</sub> laser-induced fluorescence spectrum was analyzed; it was calibrated by comparison with the same feature observed in the absence of the heating laser beam. The procedure, based on a comparison of experimental and simulated spectra, was very simple and efficient, but it suffered from several limitations. On one hand, it did not take advantage of the full experimental data set, the observed spectrum consisting of 5 peaks extending from 220 to 260 nm. More questionable was the calibration, since the two compared spectra recorded in the presence and in the absence of the CO<sub>2</sub> laser beam were observed independently; therefore, the experimental conditions—in particular, the geometry of the absorbing zone—were not identical. On the other hand, the rotational variation in the predissociation rate in the <i>B</i> state of O<sub>2</sub>, which is, indeed, fairly large (in particular, for <i>u</i><sub><i>B</i></sub> = 6, 7, 9), was neglected. In the present paper, we describe a more refined spectral analysis of the 230–260 nm region of the LIF spectrum. A comparison with the 300 K LIF spectrum is unnecessary when the spectral simulation analysis is extended to several peaks; the shape of the different features and the relative intensity provide internal consistency. The earlier neglect of the rotational variation of the B quantum yield resulted in an underestimation of the population of the higher vibrational levels (<i>u</i><sub><i>x</i></sub> = 2, 3) and, therefore, of the temperature. Eventually, the actual temperature proved to be notably higher than our previous estimation (700 K).

PDF Article
More Like This
Single-pulse, two-line temperature-measurement technique using KrF laser-induced O2 fluorescence

J. H. Grinstead, G. Laufer, and J. C. McDaniel
Appl. Opt. 34(24) 5501-5512 (1995)

Method for measuring temperatures and densities in hypersonic wind tunnel air flows using laser-induced O2 fluorescence

Gabriel Laufer, Robert L. McKenzie, and Douglas G. Fletcher
Appl. Opt. 29(33) 4873-4883 (1990)

Cited By

You do not have subscription access to this journal. Cited by links are available to subscribers only. You may subscribe either as an Optica member, or as an authorized user of your institution.

Contact your librarian or system administrator
or
Login to access Optica Member Subscription

Select as filters


Select Topics Cancel
© Copyright 2024 | Optica Publishing Group. All Rights Reserved