Abstract

For the purpose of realizing a fast and cost-efficient manipulation of the laser beam in production applications, such as welding, marking, and cutting, scanner systems in combination with F-Theta objectives are state-of-the-art. Owing to the absorption of the laser beam power and the resulting heat load acting on the optical system, a change of the focal plane (the so-called focal shift) occurs, significantly affecting the behavior during the application process. A linear correlation between the temperature on the optical surface of a standard F-Theta objective and the focal shift was determined whereby the coefficient of determination $R^2$ is higher than 0.99. Furthermore, two industrial welding applications were investigated using this standard objective, and the resulting temperature distribution along the optical surfaces was also investigated. The results show that a single measurement point appears to be sufficient to obtain a capable input signal for a compensation method. A compensation device was implemented and a sufficient reduction of the focal shift was realized for the examined time range.

© 2018 Optical Society of America

Measurement and compensation of laser-induced wavefront deformations and focal shifts in near IR optics

Martin Stubenvoll, Bernd Schäfer, and Klaus Mann
Opt. Express 22(21) 25385-25396 (2014)

Long focal length high repetition rate femtosecond laser glass welding

Marion Gstalter, Grégoire Chabrol, Armel Bahouka, Kokou-Dodzi Dorkenoo, Jean-Luc Rehspringer, and Sylvain Lecler
Appl. Opt. 58(32) 8858-8864 (2019)

Determination of the thermally induced focal shift of processing optics for ultrafast lasers with average powers of up to 525 W

Sebastian Faas, Daniel J. Foerster, Rudolf Weber, and Thomas Graf
Opt. Express 26(20) 26020-26029 (2018)

Passive compensation of laser-induced higher-order aberrations in high-power NIR optics

Martin Stubenvoll, Bernd Schäfer, and Klaus Mann
Opt. Express 25(21) 25407-25415 (2017)

Analysis of short wavelength infrared radiation during laser welding of plastics

J. Martan, J. Tesař, M. Kučera, P. Honnerová, M. Benešová, and M. Honner
Appl. Opt. 57(18) D145-D154 (2018)