Abstract

No abstract available.

Full Article  |  PDF Article

References

  • View by:
  • |
  • |
  • |

  1. K. H. Edensor, K. J. Loughry, H. M. P. Stock, to be submitted to Metrologia.
  2. W. H. Steel, in Optical Instruments and Techniques, J. Home Dickson, Ed. (Oriel, Newcastle-upon-Tyne, 1970), p. 78.
  3. Epoxy Technology Inc., 14 Fortune Drive, P.O. Box 567, Billerica, Mass. 01821.
  4. J. A. Seckold, Appl. Opt. 22, 204 (1983).
    [CrossRef] [PubMed]

1983

Edensor, K. H.

K. H. Edensor, K. J. Loughry, H. M. P. Stock, to be submitted to Metrologia.

Loughry, K. J.

K. H. Edensor, K. J. Loughry, H. M. P. Stock, to be submitted to Metrologia.

Seckold, J. A.

Steel, W. H.

W. H. Steel, in Optical Instruments and Techniques, J. Home Dickson, Ed. (Oriel, Newcastle-upon-Tyne, 1970), p. 78.

Stock, H. M. P.

K. H. Edensor, K. J. Loughry, H. M. P. Stock, to be submitted to Metrologia.

Appl. Opt.

Other

K. H. Edensor, K. J. Loughry, H. M. P. Stock, to be submitted to Metrologia.

W. H. Steel, in Optical Instruments and Techniques, J. Home Dickson, Ed. (Oriel, Newcastle-upon-Tyne, 1970), p. 78.

Epoxy Technology Inc., 14 Fortune Drive, P.O. Box 567, Billerica, Mass. 01821.

Cited By

OSA participates in CrossRef's Cited-By Linking service. Citing articles from OSA journals and other participating publishers are listed here.

Alert me when this article is cited.


Figures (6)

Fig. 1
Fig. 1

Assembled cube corners.

Fig. 2
Fig. 2

Polishing of main member block assembly.

Fig. 3
Fig. 3

Block construction for polishing faces of main member. Main member removed for clarity.

Fig. 4
Fig. 4

Checking angles during polishing.

Fig. 5
Fig. 5

Interferograms showing flatness of three polished faces of larger main member after deblocking.

Fig. 6
Fig. 6

Smaller cube corner mounted on traveling carriage. Tape to be measured shown at the apex of the cube corner.

Metrics