Abstract
We report a study of the basic characteristics of laser polishing of fused silica with a protocol that is particularly suitable for surface smoothing of micro-optic elements fabricated by a laser ablation process. We describe a new, to our knowledge, approach based on scanning a highly controlled small size laser beam and melting areas of tens to hundreds of micrometers of glass using a computer-controlled raster scan process, which does not require beam shaping, substrate preheating, or special atmospheres. Special test samples of silica substrates with prescribed spatial frequency content were polished using a range of irradiation conditions with the beam from a well-controlled laser operating at a wavelength of . An analysis is presented of the laser-generated reduction in surface roughness in terms of measurements of the spatial frequency characteristics, and the results are compared with the predictions of a simple model of surface-tension-driven mass flow within the laser-melted layer. This technique is shown to be capable of smoothing silica surfaces with scale roughness down to levels with no net effect on the as-machined net surface shape, at realistic production rates without a preheating stage, and with noncritical residual stresses.
© 2006 Optical Society of America
Full Article | PDF ArticleMore Like This
E. Mendez, K. M. Nowak, H. J. Baker, F. J. Villarreal, and D. R. Hall
Appl. Opt. 45(21) 5358-5367 (2006)
Gavin A. J. Markillie, Howard J. Baker, Francisco J. Villarreal, and Denis R. Hall
Appl. Opt. 41(27) 5660-5667 (2002)
F. Laguarta, N. Lupon, and J. Armengol
Appl. Opt. 33(27) 6508-6513 (1994)